GN decanter centrifuge with the plastic adding equipments

GN Solids Control has provided many cost effective devices for the solids control along with drill cuttings treat. Right now we would like to show you GN decanter centrifuge with the plastic adding equipments, this entire system can be also called dewatering unit because it helps to spend less water and keep the effectiveness of the drilling fluids.

GN Polymer Adding Unit
We all know, GN Solids Control gadgets such as shaker, desander, desilter, decanter centrifuge are used to distinct the particles larger than 2~5 microns in the drilling essential fluids. For the solids that small compared to 2 microns, we need to different them out with the guidance of polymers and chemical substances. If we don’t separate all these finer solids, form a good run the characteristics on the drilling fluids will be in a unstable status. The most common approach to solve it is adding a lot more water which waste waters and also caused more going waste.

2015.06.06_high_skid_decanter_centrifuge
Now by using GN decanter centrifuge with polymer bonded, we can solve all the earlier mentioned problems. GN dewatering device is mainly including the following factors:
1 . GN mud Mixing System
This system is used to incorporate powder polymer automatically whenever this system is added in with enough polymer powdered ingredients and the inside water tension reach a certain level. Mixing capacity is 2000 l/h. Polymer concentration is around zero. 05%~0. 5%.
2 . GN Coagulant System
The tank here is made of polyurethane; a single mud agitator is set in the middle. Treating capacity can certainly reach to 1500L.
three or more. GN Feeding System
You will discover two feeding systems: the first is for feeding polymer flocculants, the other is feeding coagulant. Both of them will be nourish into GN decanter centrifuge for further separation.
4. GN 20 Feet Container
Each of the above equipments are permanent inside. After treated with that dewatering system, all the going fluids with mixed plastic and coagulant will be driven into GN decanter centrifuge, so the particles larger than 2~5 microns can be separated out there.

Leave a Reply

Your email address will not be published. Required fields are marked *